Logo Robot 1

Hello my friend

Thank you for purchasing this file; Before using, note that I made these parts with a cheap 3D printer, so the tolerances I have between the parts apply to my printer.

Be sure to calibrate your printer before making the parts completely so that you don't face any problems.

Pay attention to this example:

I have used screw number 3 to connect the parts, but if you check the maps carefully, you will find that the holes of these screws have a diameter of 3.6 mm. This is because of the low accuracy of my printer, and you should correct the diameter of the holes according to the accuracy of your printer before making.

You can see the assembly tutorial on my YouTube channel.

https://www.youtube.com/channel/UCAxBiQa3AcetQivzTHIX4Dg

Thank you for reading the guide.

good luck.